this time out value to 150s or higher. The higher timeout value can help to reduce the
load of our backend ceph cluster and also can avoid throttling issues at sidecars to an extent.
Fix# #602
Signed-off-by: Humble Chirammal <hchiramm@redhat.com>
rootfs dependency was removed from rbd
by removing support for `nsenter`, This
PR removed the `/` mount from provisioner
Signed-off-by: Madhu Rajanna <madhupr007@gmail.com>
if both controller and nodeserver flags are set/unset
cephcsi will start both server,
if only one flag is set, it will start relavent
service.
Signed-off-by: Madhu Rajanna <madhupr007@gmail.com>
The container runtime CRI-O limits the number of PIDs to 1024 by
default. When many PVCs are requested at the same time, it is possible
for the provisioner to start too many threads (or go routines) and
executing 'rbd' commands can start to fail. In case a go routine can not
get started, the process panics.
The PID limit can be changed by passing an argument to kubelet, but this
will affect all pids running on a host. Changing the parameters to
kubelet is also not a very elegant solution.
Instead, the provisioner pod can change the configuration itself. The
pod is running in privileged mode and can write to /sys/fs/cgroup where
the limit is configured.
With this change, the limit is configured to 'max', just as if there is
no limit at all. The logs of the csi-rbdplugin in the provisioner pod
will reflect the change it makes when starting the service:
$ oc -n rook-ceph logs -c csi-rbdplugin csi-rbdplugin-provisioner-0
..
I0726 13:59:19.737678 1 cephcsi.go:127] Initial PID limit is set to 1024
I0726 13:59:19.737746 1 cephcsi.go:136] Reconfigured PID limit to -1 (max)
..
It is possible to pass a different limit on the commandline of the
cephcsi executable. The following flag has been added:
--pidlimit=<int> the PID limit to configure through cgroups
This accepts special values -1 (max) and 0 (default, do not
reconfigure). Other integers will be the limit that gets configured in
cgroups.
Signed-off-by: Niels de Vos <ndevos@redhat.com>
This change also starts mapping nbd based access using ther rbd CLI
as, it is a prerequisite to get device listing for nbd as well.
Signed-off-by: ShyamsundarR <srangana@redhat.com>
Use Deployment with leader election instead of StatefulSet
Deployment behaves better when a node gets disconnected
from the rest of the cluster - new provisioner leader
is elected in ~15 seconds, while it may take up to
5 minutes for StatefulSet to start a new replica.
Refer: kubernetes-csi/external-provisioner@52d1fbc
Signed-off-by: Madhu Rajanna <madhupr007@gmail.com>
